Prime Discovers New Wide Zones Of High-Grade Mineralization in Z-T Area Significantly Below Resource Pits
VANCOUVER, June 20, 2023 - Prime Mining Corp. ("Prime" or the "Company") (TSX-V: PRYM, OTCQX: PRMNF, Frankfurt: 04V3) is reporting drill results from four holes at the Z-T Area, one of three main zones hosting the gold-silver mineral resource estimate ("MRE") announced May 2, 2023 at the Company's Los Reyes Project located in Sinaloa State, Mexico. A 2023 Technical Report was filed on June 13, 2023 and can be found on the Company's website at https://primeminingcorp.ca/ and on SEDAR at www.sedar.com, under the Company's Issuer Profile.
Two of the new core holes drilled at Tahonitas, in the southeast end of the Z-T Area (see Figures 1, 2), are located 100 to 200 metres below the recently announced resource pit shell. This drilling follows Prime's news release of May 24, 2023 (link here), confirming the ongoing expansion of potential gold-silver resources in addition to and not included in the Company's MRE.
Z-T Drilling Highlights:
- 5.10 gpt AuEq (3.96 gpt Au and 88.0 gpt Ag) over 11.4 m etw in hole 23TA-67, located 200 m below the MRE resource pit, including:
- 27.20 gpt AuEq (24.50 gpt Au and 209.0 gpt Ag) over 1.5 m etw.
- 4.86 gpt AuEq (3.80 gpt Au and 82.0 gpt Ag) over 13.3 m etw in hole 23TA-69, located 100 m below the MRE resource pit, including:
- 9.30 gpt AuEq (8.15 gpt Au and 89.2 gpt Ag) over 3.7 m etw.
Together the mineralization in these drill holes further defines two high-grade mineralized shoots separated by 250 m. These intercepts open a significant area of exploration upside relative to the MRE pit shell for the Z-T Area. They suggest a potential merging of the western, shallow plunging mineralized shoot encountered by hole 23TA-67 and the eastern, steeply plunging mineralized shoot intercepted by 23TA-69 (see Figure 3).
Prime Mining Corp. Chief Executive Officer Daniel Kunz commented, "Today's exciting results from Z-T are significant as they further demonstrate high-grade mineralization at depth, and open significant potential for mineralization in these currently untested gaps. These are among the highest grades and deepest intercepts we have encountered at Z-T to date. We have been very encouraged with the results post-resource drilling cutoff at the south end of the Z-T structure. As a result, we will continue to focus on this area of the orebody, both down dip and along strike."
Drilling will be ongoing through the upcoming rainy season with four drill rigs focusing on:
- extending the high-grade Z-T shoots that remain open at depth, as well as along strike north and south;
- expanding the two other MRE resource areas, including the eastern extensions of the Guadalupe System and Echeguran Shaft area; and,
- exploring the new generative targets.
Figures 3 to 5 provide a visual summary of the Z-T Area extension drill program incorporating today's reported drill results. Hole 23TA-67 is at an elevation of 320 masl and mineralization remains open at depth. Prime has already completed over 28,000 m of its planned 60,000 m 2023 drill program and will continue to evaluate its drilling plans using its success-based approach.
Figure 1: Los Reyes drilling update
Figure 2: Z-T drilling update
Figure 3: Z-T long section
Figure 4: Z-T (Tahonitas area) cross section A-A'
Figure 5: Z-T (Tahonitas area) cross section B-B'
Link 1 - PDF Figures
Link 2 - PDF Drill Hole Tables
Note 1: Gold equivalent grades are calculated based on an assumed gold price of $US 1700 per ounce and silver price of $22 per ounce, based on the formula AuEq grade (gpt) = Au grade + Ag grade x ($22 / $1,700). Metallurgical recoveries are not considered in the in-situ grade estimate but are estimated to be 93% and 83% for gold and silver, respectively, when processed in a mill, and 72% and 25% respectively when heap-leached.
QA/QC Protocols and Sampling Procedures
Drill core at the Los Reyes project is drilled in predominately HQ size (63.5 millimetre "mm"), reducing to NQ (47.6 mm) when required. Drill core samples are generally 1.50 m long along the core axis with allowance for shorter or longer intervals if required to suit geological constraints. After logging intervals are identified to be sampled, the core is cut and one half is submitted for assay. RC drilling returns rock chips and fines from a 133.35 mm diameter tricone bit. The returns are homogenized and split into 2 halves, with one half submitted for analysis and the other half stored.
Sample QA/QC measures include unmarked certified reference materials, blanks, and field duplicates as well as preparation duplicates are inserted into the sample sequence and make up approximately 8% of the samples submitted to the laboratory for each drill hole.
Samples are picked up from the Project by the laboratory personnel and transported to their facilities in Durango or Hermosillo Mexico, for sample preparation. Sample analysis is carried out by Bureau Veritas and ALS Labs, with fire assay, including over limits fire assay re-analysis, completed at their respective Hermosillo, Mexico laboratories and multi-element analysis completed in North Vancouver, Canada. Drill core sample preparation includes fine crushing of the sample to at least 70% passing less than 2 mm, sample splitting using a riffle splitter, and pulverizing a 250-gram split to at least 85% passing 75 microns.
Gold in diamond drill core is analyzed by fire assay and atomic absorption spectroscopy of a 30 g sample (code FA430 or Au-AA23). Multi-element chemistry is analyzed by 4-Acid digestion of a 0.25-gram sample split (code MA300 or ME-ICP61) with detection by inductively coupled plasma emission spectrometer for a full suite of elements.
Gold assay techniques FA430 and Au-AA23 have an upper detection limit of 10 ppm. Any sample that produces an over-limit gold value via the initial assay technique is sent for gravimetric finish via method FA-530 or Au-GRA21. Silver analyses by MA300 and ME-ICP61 have an upper limit of 200 ppm and 100 ppm, respectively. Samples with over-limit silver values are re-analyzed by fire assay with gravimetric finish FA530 or Au-GRA21.
Both Bureau Veritas and ALS Labs are ISO/IEC accredited assay laboratories.
Qualified Person
Scott Smith, P.Geo., Executive Vice President of Exploration, is a qualified person for the purposes of National Instrument 43-101 and has reviewed and approved the technical content in this news release.
Additional Notes
Metres is represented by "m"; "etw" is Estimated True Width and is based on drill hole geometry or comparisons with other on-section drill holes; "Au" refers to gold, and "Ag" refers to silver; "gpt" is grams per metric tonne; some figures may not sum due to rounding; Composite assay grades presented in summary tables are calculated using a Au grade minimum average of 0.20 gpt or 1.0 gpt as indicated in "Au Cut-off" column of Summary Tables. Maximum internal waste included in any reported composite interval is 3.00 m. The 1.00 gpt Au cut-off is used to define higher-grade "cores" within the lower-grade halo.
About the Los Reyes Gold and Silver Project
Los Reyes is a rapidly evolving high-grade, low sulphidation epithermal gold-silver project located in Sinaloa State, Mexico. Since acquiring Los Reyes in 2019, Prime has spent approximately US$30 million on direct exploration activities and has completed over 120,000 m of drilling. On May 2, 2023, Prime announced an updated multi-million-ounce high-grade open pit constrained resource (see below, and refer to Note 1 and the May 2, 2023 press release for more details).
May 2, 2023 Resource Statement
Drilling is on-going and suggests that the three known main deposit areas (Guadalupe, Central and Z-T) are larger than previously reported. Potential also exists for new discoveries where mineralized trends have been identified outside of the currently defined resource areas.
Historic operating results indicate that an estimated 1 million ounces of gold and 60 million ounces of silver were recovered from five separate operations at Los Reyes between 1770 and 1990. Prior to Prime's acquisition, recent operators of Los Reyes had spent approximately US$20 million on exploration, engineering, and prefeasibility studies.
About Prime Mining
Prime is managed by an ideal mix of successful mining executives, strong capital markets personnel and experienced local operators all focused on unlocking the full potential of the Los Reyes Project. The company has a well-planned capital structure with a strong management team and insider ownership.
ON BEHALF OF THE BOARD OF DIRECTORS
Daniel Kunz
Chief Executive Officer
For further information, please contact:
Daniel Kunz
Chief Executive Officer and Director
Prime Mining Corp.
1307 S. Colorado Ave.
Boise, Idaho 83706
Telephone: +1 (208) 926-6379 office
email: daniel@primeminingcorp.ca
Scott Hicks
Executive Vice President
Prime Mining Corp.
710 - 1030 West Georgia Street
Vancouver, BC, V6E 2Y3
Telephone: +1 (604) 428-6128 office
email: scott.hicks@primeminingcorp.ca
Neither the TSX Venture Exchange nor its Regulation Services Provider (as that term is defined in policies of the TSX Venture Exchange) accepts responsibility for the adequacy or accuracy of this release.
Forward Looking Information
This news release contains certain "forward-looking information" and "forward-looking statements" within the meaning of Canadian securities legislation as may be amended from time to time, including, without limitation, statements regarding the perceived merit of the Company's properties, including additional exploration potential of Los Reyes, potential quantity and/or grade of minerals, the potential size of the mineralized zone, metallurgical recoveries, and the Company's exploration and development plans in Mexico. Forward-looking statements are statements that are not historical facts which address events, results, outcomes, or developments that the Company expects to occur. Forward-looking statements are based on the beliefs, estimates and opinions of the Company's management on the date the statements are made, and they involve several risks and uncertainties. Certain material assumptions regarding such forward-looking statements were made, including without limitation, assumptions regarding the price of gold, silver and copper; the accuracy of mineral resource estimations; that there will be no material adverse change affecting the Company or its properties; that all required approvals will be obtained, including concession renewals and permitting; that political and legal developments will be consistent with current expectations; that currency and exchange rates will be consistent with current levels; and that there will be no significant disruptions affecting the Company or its properties. Consequently, there can be no assurances that such statements will prove to be accurate and actual results and future events could differ materially from those anticipated in such statements. Forward-looking statements involve significant known and unknown risks and uncertainties, which could cause actual results to differ materially from those anticipated. These risks include, but are not limited to: risks related to uncertainties inherent in the preparation of mineral resource estimates, including but not limited to changes to the cost assumptions, variations in quantity of mineralized material, grade or recovery rates, changes to geotechnical or hydrogeological considerations, failure of plant, equipment or processes, changes to availability of power or the power rates, ability to maintain social license, changes to interest or tax rates, changes in project parameters, delays and costs inherent to consulting and accommodating rights of local communities, environmental risks, title risks, including concession renewal, commodity price and exchange rate fluctuations, risks relating to COVID-19, delays in or failure to receive access agreements or amended permits, risks inherent in the estimation of mineral resources; and risks associated with executing the Company's objectives and strategies, including costs and expenses, as well as those risk factors discussed in the Company's most recently filed management's discussion and analysis, as well as its annual information form dated April 22, 2022, available on www.sedar.com. Except as required by the securities disclosure laws and regulations applicable to the Company, the Company undertakes no obligation to update these forward-looking statements if management's beliefs, estimates or opinions, or other factors, should change.
Figures accompanying this announcement are available at:
https://www.globenewswire.com/NewsRoom/AttachmentNg/8f546cd9-bfce-47fc-815b-99d89c14d881
https://www.globenewswire.com/NewsRoom/AttachmentNg/c9d72dfb-307d-4d2b-bfc4-479d428b448f
https://www.globenewswire.com/NewsRoom/AttachmentNg/1b15198c-532a-456a-b14c-263572cd9536
https://www.globenewswire.com/NewsRoom/AttachmentNg/c0e20cdb-e3a9-472a-a886-341c6bebd737
https://www.globenewswire.com/NewsRoom/AttachmentNg/f6388f6a-a714-4e79-9beb-04a33e49f865
https://www.globenewswire.com/NewsRoom/AttachmentNg/3de0dd86-fc57-44f5-a6a2-a8b8e0588885
